185

TRUCK & CAR SEAT SOLUTION

MOST TRUCKS & SOME AUTOS
STARTED IN 1982 WITH FLEX-O-LATORS® IN THE SEAT WITH FOAM ON
TOP INSTEAD OF SPRINGS.

IF YOU HAVE GOT A SEAT WITH MOST OF THE SPRINGS BROKEN, REMOVE
ALL OF THE SPRINGS AND REPLACE THEM WITH A FLEX-O-LATOR ®.
YOU ATTACH THE FLEX-O-LATOR® TO THE FRONT RAIL OF THE SEAT
FRAME WITH HOSE CLAMPS, THEN DRILL HOLES 6" APART ON THE BACK
RAIL OF FRAME. FLEX-O-LATOR® SHOULD BE 3" TO 4" NARROWER THAN
THE SEAT FRAME. THEN YOU HOOK THE HELICAL SPRINGS IN THE HOLES
YOU DRILL IN THE BACK FRAME RAIL AND HOOK THE HELICAL ON
THE FLEX-O-LATOR®. HOG RING, BURLAP, OR F.L.W CLOTH OVER
THE FLEX-O-LATOR® AND GLUE THICK FOAM RUBBER SEATING TO BURLAP
THIS WILL GIVE YOU A VERY GOOD SEAT, TRY IT... IT WORKS VERY WELL!!
FLEX - O - LATORS®


WE CARRY THE FLEX-O-LATORS® AND HELICAL SPRINGS FOUND
IN LATE MODEL (1983-95) TRUCK SEATS, (NOW CARS USE THEM TOO).
OURS ARE LONGER THAN THE ORIGINAL BECAUSE THE ORIGINAL
ONES WERE TOO SHORT AND THE FOAM WOULD GO DOWN BETWEEN
THE FLEX-O-LATOR® AND THE SEAT FRAME, YOU CAN CUT THEM TO LENGTH.


F8--8" X 60" LONG FLEX-O-LATOR®
F10--10" X 60" LONG FLEX-O-LATOR®
F12--12" X 60" LONG FLEX-O-LATOR®
F13--13-1/2" X 60" LONG FLEX-O-LATOR®
F14--14-1/2" X 60" LONG FLEX-O-LATOR®
F15--15-1/2" X 60" LONG FLEX-O-LATOR®
F16--16-1/2" X 60" LONG FLEX-O-LATOR®

S11-- 2-3/4" HELICAL SPRING


PERMA-MESH®
DISCONTINUED, WHILE SUPPLIES LAST

* PERMA-MESH® IS USED TO BRIDGE OVER S-ARCH SPRINGS ONLY *

P16--16" WIDE PERMA-MESH® 50 FT. ROLL
P22--22" WIDE PERMA-MESH® 50 FT. ROLL
P24--24" WIDE PERMA-MESH® 50 FT. ROLL
P60--60" WIDE PERMA-MESH® 50 FT. ROLL.

FLEX-O-LATER® AND PERMA-MESH® ARE REGISTERED
TRADE NAMES OF LEGGETT & PLATT.


HOME Page